or YouTube link

I have not been doing a good job at keeping up with posting about the 3D Printer.  I have managed to take a number of pictures which show th...

Partnering with my dad, we have designed and built our very own custom 3D printer. He has done the bulk of the mechanical design and fabric...

In the last post, I briefly mentioned that I planned on adding a 'heat sink' to my motor driver board in order to prevent it from ov...

I am slowly working toward the balancing robot Arduino shield stack.  So far, I have tested the XBee shield by sending information from t...

After months of doing next to nothing with my electronics, I have finally jumped back into it.  This time I have come back with an Arduino! ...

There are plenty of examples on how to set-up a pair of XBees on the web, but since I had some trouble, I thought I would share my resources...